Filter
Top Products
UC360 Administration and User Guide
76
MCD Programming for the UC360
This section describes the MCD settings for the UC360.
Refer to the MCD System Administration Tool Online Help for detailed instructions on how
to program SIP Device Capabilities on the MCD system.Only MCD certified technicians should
be programming the UC360 on the MCD.
The UC360 is a SIP device and can only be programmed on the MCD in Release 1.0. Licensing
is also required on the MCD for the SIP Device. Refer to the UC360 Engineering Guidelines
for more details on licensing.
The information provided below is based on MCD Release 5.0 SP2 PR1 (the minimum MCD
release supporting the UC360) and may change; however, these instructions will still aid you
in programming the UC360 for use on the MCD.
Program the following forms in MCD:
• “User and Device Configuration” on page 77
• “SIP Device Capabilities” on page 81