Filter
Top Products
UC360 Administration and User Guide
56
Media
Under Media, set the following parameters:
• Audio CODEC List — specify the preferred order for audio CODEC usage. Refer to the
section on CODECs and bandwidth in the UC360 Engineering Guidelines for more
information.
- If G.729a has been enabled, and you then enable and disable H.264, the G729a
setting is still preserved even though it does not display in the Audio codec list.
• Video CODEC List — specify the preferred order for video CODEC usage.
- The UC360 must be reset if the H.264 video codec is not enabled, and has been
enabled for the first time.
- G.729 is disabled and not available from the System Settings -> SIP Settings ->
Audio codec list menu for the Remote Collaboration/Video Appliance variant of the
UC360. This ensures the best audio quality.
- If G729 is required, an administrator can enable it manually.
• Packet Time — set the preferred packet time from 20 ms to 100 ms in 10 ms increments.
A packet time of 20 ms is recommended. Note: Certain CODECS may only operate in 20
ms increments.
• DTMF Mode — the UC360 sends DTMF signaling both in-band and out of band.
• DTMF Payload — set the In-Band payload number to a value between 96 and 127. 101 is
the default value. It is recommended to leave this at the default value. For third party SIP
severs, consult the vendor’s documentation as to how to set the DTMF Payload value.
Registration Time Out
This is the SIP registration time out value in seconds. It is recommended to leave this at the
factory default setting of 3600 seconds.
Proxy Server Address
This is the SIP Proxy server IP address (IPv4).
Keep Alive Interval
This is the SIP keep-alive interval in seconds. It is recommended to leave this at the factory
default setting of 0, which is disabled.
If the UC360 is used as a Telewoker set, then input the Keep Alive Interval required by MBG.