Filter
Top Products
UC360 Configuration
55
SIP Settings
Prerequisites
• Before configuring SIP settings, ensure that MCD programming is competed. See “MCD
Programming for the UC360” on page 76.
• Obtain the SIP Server address name, User Name, and Login Name from the User and
Device Configuration form.
1. Press Settings
2. Press Advanced
3. Press System Settings
4. Press SIP Settings
See the information below for the parameters to configure. For a list of all the settings and their
default options, see the UC360 Engineering Guidelines.
Account
Under Account, set the following parameters:
• SIP Server Address — the IP address (IPv4) or the FQDN format address of the SIP server.
• Username — the SIP user’s ID. It is the DN (extension number) assigned on the SIP server.
• Display Name — the displayable caller name, e.g. John Brown.
If Mitel Border Gateway (MBG) is part of the MCD setup, the parameters need to be set as
follows:
• SIP Server Address — the MBG server address
• Username — the SIP users's ID (programmed in MBG)
• Login Name — the DN
Note: For correct operation with the UC360, the MBG must be running a minimum of MBG 7.1
SP1 software.
Authentication
Under Authentication, set the login name and password.
Transport
Under Transport, enable or disable the following setting:
• UDP — the UC360 should be configured for UDP.
• TCP/IP — Not applicable