Filter
Top Products
7. Close the GREEN drain valve and open the RED Return valve.
8. Return the oil to the fry tank. When air bubbles are present in
the fry tank turn the pump OFF.
9. Close the RED return valve.
10. Turn the fryer ON as described in the operation section.
SHUTTING THE FRYERS DOWN:
Press the Power switch to the OFF position.
OPERATING THE COMPUTER CONTROL:
To check the ACTUAL Temperature Press the key
(After 5 seconds the display will return to the run
mode.)
To check the SET Temperature Press the
key two
times. (After 5 seconds the display will return to the run
mode.)
To check the COOK, SHAKE or HOLD times press the
key and the desired PRODUCT NUMBER
key. (The times will be automatically displayed in sequence, the display will return to the run mode.)
The BOIL mode will be automatically displayed when the computer senses a constant temperature of 100
ºC. This will only happen when water is in the machine during the Weekly Cleaning process. To cancel
the BOIL mode, turn the machine off and ON again. The computer will automatically exit the BOIL mode
when the oil temperature exceeds 100 ºC.
PROGRAMMING THE COMPUTER CONTROL:
To program the SET Temperature press
and enter the desired Temperature.
To return to the COOK mode at any time press
.
To set COOK TIME press
and a PRODUCT KEY. Enter the desired time and press to set its
SHAKE TIME. Press
again to set its HOLD TIME. Press & to return to the COOK
mode.
To enter the next level of programming press
and enter the PASSWORD (if one is set). Press and
SELECT will be displayed.
To change from ºF to ºC press
and use to toggle between the options.
To set the PASSWORD option press
to display SET PASS and use to toggle between PASREQ
and NOPASS. When a PASSWORD is required press
and set the desired four digit password.
To set the BEEPER VOLUME press
and use to toggle between the three available volume levels.
To set the LANGUAGE option press
and use to toggle between the available options.
To set the desired MELT CYCLE option press
and use to toggle between the NO MELT, LIQUID
& SOLID melt cycle options.
To view the RECOVERY TEST TIME press
and use again to display the recovery data.
To change CONTROL modes press
and use to toggle between COMPUTER and TIMER control
modes.
OPERATING THE DIGITAL CONTROL:
Press the key to turn the machine ON and OFF.
Press the key to start the Left Hand TIMER and BASKET LIFT (when installed.)
4
ENGLISH
Figure 2.
Filter Pan
Indicator Light
Green
Drain
Valve
Red
Return
Valve
Red
Return
Valve
Pump Switch