Filter
Top Products
Flue riser top
FIGURE 2
ITEM
PART NUMBER
A
1176423
B
114-6303
DESCRIPTION
Pan Deflector Bracket
#8
x l/2” Screw
NOTICE
Local codes regarding installation vary greatly from one area to another. The National Fire Protection
Association, Inc. states in its NFPA 96 latest edition that local codes are the “authority having jurisdic-
tion” when it comes to installation requirements for equipment. Therefore, installations should comply
with all local codes.
EXHAUST FANS AND CANOPIES: c
anopies are set over ranges, ovens, etc.,
for
ventilation purposes. It
is recommended
that a canopy extend 6” past the appliance and the bottom edge be located 6’6” from the floor. Filters
should be installed at an angle of 45 degrees or more from horizontal. This position prevents dripping grease and facili-
tates collecting the run-off grease in a drip pan, usually installed with a filter. A strong exhaust fan tends to create a
vacuum in the room and may interfere with burner performance or may extinguish pilot flames. Fresh air openings
approximately equal to the fan area will relieve such a vacuum.
WALL EXHAUST FAN:
The exhaust fan should be installed at least 2” above the vent opening at the top of the
unit.
DIRECT CONNECTION:
If the unit is connected directly to an outside flue, an AGA/CGA design certified down
draft diverter must be installed at the flue outlet of the oven and connected to the flue.
In case of unsatisfactory performance on any appliance, check the appliance with the exhaust fan in the “OFF” position.
Do this only long enough to check equipment performance. Then turn hood back on and let it run to remove any
exhaust that may have accumulated during the test.
NOTICE
Proper ventilation is the owner’s responsibility. Any problem due to improper ventilation will not be
covered by warranty.
A WARNING
Improper ventilation can result in personal injury or death. Ventilation which fails to properly remove flue
products can cause headaches, drowsiness, nausea, or could result in death.
PAGE 8