Filter
Top Products
5 – Recording—Copy-protection
38 TASCAM CD-RW402 Owner’s Manual
To perform a fade-in:
1 With a recordable disc loaded, press the
RECORD key so that the unit enters record
ready mode.
2 Start the source material, and press the
FADER key.
As the fade progresses, the monitored signal
gradually becomes louder, reflecting the level
recorded on disc.
To perform a fade-out:
1 While recording, press the FADER key.
As the fade progresses, the monitored signal
gradually becomes quieter, reflecting the
level recorded on disc.
2 When the end of the fade-out time is reached,
the unit goes into record ready mode.
Recording can be restarted with the
FADER
key or the
PLAY or READY keys.
It is not possible to change the fade-in and fade-out
times to new values while recording is in progress.
Copy-protection
The CD-RW402 allows copy-protection to be applied
to the discs produced. Naturally, the copy-protection
applies only to digital-to-digital copies made from
the discs produced on the CD-RW402.
There are three settings:
•
FREE (may be freely copied), where no copy-protec-
tion is applied to the recorded disc.
•
1GEN (single-generation copying), where one digital
copy (“child”) can be made from the recorded disc,
but no digital copies (“grandchildren”) can be
made from the child.
•
PROH (copy prohibited) which prevents any digital
copies being made from the recorded disc
1 Press the
MENU key (2) and turn the MULTI
DIAL
to display REC MENU 1 ?.
2 Press the
MULTI DIAL.
3 Turn the
MULTI DIAL until the display shows
COPY ID ?.
4 Press the
MULTI DIAL.
5 Turn the
MULTI DIAL to change the fade time
COPY ID> setting between FREE, PROH and 1GEN.
6 Press the
MULTI DIAL to make the setting and
leave the menu.
NOTE
Copy-protection applies on a ““per-track”, not a per-disc
basis. This means that you can apply different copy-protec-
tion levels to different tracks (but you can’t apply different
copy-protection levels to different parts of the same track).
If copy-protection is important to your work, you may want
to check this setting every time you make a recording, to
ensure that you have the protection level that you want.