Filter
Top Products
9 – External control—CONTROL I/O
TASCAM CD-RW402 Owner’s Manual 51
CONTROL I/O
This connector allows for remote control by suitably-
equipped units, and provides tally information to
such units.
The total current of pin 6 (+5 V) and pin 8 must be
less than 100 mA.
Input signals are active when grounded for at least
30 ms.
Output signals are connected to an open collector
with maximum voltage 15 V, and maximum current
50 mA.
Pin Signal name IN/OUT
1 PLAY command (drive 2) IN
2 STOP command (drive 2) IN
3 CALL command (drive 2) IN
4 FADER command (drive 2) IN
5 Not connected –
6+5V –
7 Not connected –
8+5V –
9 Not connected –
10 PLAY command (drive 1) IN
11 STOP command (drive 1) IN
12 CALL command (drive 1) IN
13 FADER command (drive 1) IN
14 PLAY tally (drive 2) OUT
15 READY tally (drive 2) OUT
16 EOM tally (drive 2) OUT
17 GND –
18 Not connected –
19 Not connected –
20 Not connected –
21 Not connected –
22 PLAY tally (drive 1) OUT
23 READY tally (drive 1) OUT
24 EOM tally (drive 1) OUT
25 GND –