Filter
Top Products
5 – Recording—Index operations
TASCAM CD-RW402 Owner’s Manual 39
Index operations
Many CDs contain index information as sub-track
divisions, often in classical music to mark scene divi-
sions in opera or the beginning of instrumental pas-
sages, etc. The CD-RW402 also supports indexes,
and allows you to carry out a number of useful opera-
tions with regard to them.
Note that although both drives of the CD-RW402 can
display index markers, there is no index locate facil-
ity built into the CD-RW402.
Index increment
Whether the index increment option is on or off (see
below), it is possible to increment the index markers
manually by pressing the drive 2
CALL key as
recording takes place.
However, by setting the index increment option on,
index markers outside the tracks in the SUB-Q code
of SPDIF digital signals will be automatically
recorded. Index numbers are shown in small digits to
the right of the track number.
1 Press the
MENU key (2) and turn the MULTI
DIAL
to display REC MENU 2 ?.
2 Press the
MULTI DIAL.
3 Turn the
MULTI DIAL until the display shows
INDEX INC ?.
4 Press the
MULTI DIAL.
5 Turn the
MULTI DIAL to change the fade time
IndexInc> setting between ON and OFF.
6 Press the
MULTI DIAL to make the setting and
leave the menu.
Setting the length of index 00
Index 00 is typically used as a lead-in track. The
default length is 1 second, but it can be set in 1-sec-
ond increments from 0 seconds to 4 seconds:
1 Press the
MENU key (2) and turn the MULTI
DIAL
to display REC MENU 2 ?.
2 Press the
MULTI DIAL.
3 Turn the
MULTI DIAL until the display shows
INDEX00 TM?.
4 Press the MULTI DIAL.
5 Turn the
MULTI DIAL to change the fade time
INDEX00> setting between 0s and 4s in 1-second
increments.
6 Press the
MULTI DIAL to make the setting and
leave the menu.
Extended check (overburning)
On some media, it is possible to record over the
stated time as marked on the disc.
To check this:
1 Press and hold the
RECORD key of drive 2
(in stop mode) for more than 2 seconds.
2 The display shows
ExtendCheck?. Press the
MULTI DIAL or REC key to start the check,
STOP to cancel the operation.
While the check is taking place, the display
shows
ExtendCheck with a flashing * (asterisk)
to the right for some time.
When the check is complete, the display
shows
COMPLETE.
The check can be interrupted by pressing the
Drive 2
STOP key. No other key is enabled
while the check is taking place.
After the check is complete, the available
time for recording may be extended, as
shown on the display.
NOTE
Although the CD-RW402 may report that extended
recording may take place on a disc, it may be that
extended recording is not actually possible when it is
attempted.
Because such extended recording does not conform to
the Orange Book standard, discs created in this way
may not be playable on other CD players.