Teka MWL 20 BIT Microwave Oven User Manual


 
28
EN
Safety tips
The following tips avoid damage to the
appliance:
Do not switch on the appliance without the
rotating base and respective plate.
Do not switch on the appliance when it is
empty. This may result in overload, if there
is no food inside.
Only use microwave-safe dishes.
Do not keep any inflammable object inside
the oven, because it may go on fire when
the oven is switched on.
Eggs with shells and whole boiled eggs
should not be heated in microwave ovens
because they may explode.
Do not heat pure alcohol or alcoholic drinks
in the microwave.
THIS IS A FIRE HAZARD.
Warning: do not heat liquids or other foods
in closed containers, because they could
easily explode.
Be careful when heating liquids!
When heating liquids (water, coffee, tea,
milk, etc.), they may almost reach boiling
point inside the appliance and if they are
removed suddenly, may fly out of the
container. This may cause injuries and
burns!
In order to avoid this type of situations, put
a plastic spoon or glass rod in the
container when heating liquids.
Be careful!
When heating small amounts of food, it is
very important not to select long periods of
time or very high power levels, because
the food may overheat or burn. For
example, bread may burn after 3 minutes if
a very high power level is selected.
To toast, only use the grill function and
supervise the oven at all times. If you are
using the combined function (microwave
and grill) to toast, the bread will go on fire
in a very short period of time.
Always heat baby food in jars or bottles
without lids or teats. After heating the food,
shake or stir it well to ensure that the heat
is uniformly distributed. Check the
temperature of the food before giving it to
the child, Burning hazard!
In case of repair:
Warning – Microwaves! The outer
protection should not be removed. Any
repair or maintenance carried out by
persons that have not been authorised by
the manufacturer is dangerous.
Warning: The light bulb may only be
replaced by the Technical Support Service.
If the power cable is damaged, only the
Technical Support Service may replace it
with one of the same characteristics, in
order to avoid damage.
Repairs and maintenance, especially of
charged parts, may only be carried out by
technicians that have been authorised by
the manufacturer.