Filter
Top Products
FIGURE 22: Wave Guide Cover/Wave Guide Removal and Replacement
To determine software type,
1. Make sure the oven is in the
COOLING
DOWN
/
OVEN OFF mode.
2. Simultaneously press the
BACK and ENTER keys.
3. Enter code 9-4-2-8 (
W-H-A-T) and press ENTER.
4. The top line on the screen will display the word
TEST, followed by the software type (for
example,
V2SWY, or TRNADO).
WAVE GUIDE COVER REPLACEMENT
The wave guide covers keep moisture and debris
out of the wave guides. If contamination gets into
the wave guides, the life of the magnetrons may be
shortened. Be careful to not allow debris to enter
the wave guides when replacing the covers.
To remove the wave guide covers, reference Figure
22 and follow the steps below:
1. Locate the fourteen (14) #8 sheet metal screws
securing the broken wave guide cover. If the
screw heads are dirty, it will be necessary to
clean the heads thoroughly.
CAUTION: Do not strip the screw heads.
2. Remove the fourteen (14) #8 screws. The cover
should come loose with gentle pressure.
x
DO NOT remove the two right and left-most
screws (Item 30). These screws secure the wave
guides to the oven floor. Only remove them if the
wave guide is also being serviced.
3. Remove the old wave guide cover and discard,
unless otherwise specified.
NOTE: It may be necessary to gently pry the
wave guide covers to remove them from the
oven floor as they are sealed with
RTV.
29
31
30
32
33
34
35
36
37
29
THE MICROWAVE SYSTEM