Turbo Chef Technologies NGC-1007 Oven User Manual


 
NOTICE:
Thi
s device complies with Part 18 of the FC
C Rules.
O
peration is subject t
o the follo
wing conditions:
1
. This devic
e may not cause harmful in
ter
ference
.
WARNING:
DHHS Feder
al Per
for
mance Standard 21 CFR 1030.10.
To provide continued protection agai
nst electr
ical
Pour assurer protec
tion
continue contre le choc
shock,
connec
t t
o
properly gr
ounded outlets only.
AVE
RTISSEMENT:
cor
rectem
ent mise a t
err
e.
electrique branche
z seulement a une prise
undes
ired opera
tion.
2. This
devic
e must acc
ept any inter
fer
ence
recei
ved
, including in
terference that may cause
Thi
s Ov
en complies with applic
able sections of
CONVECTION CIRCUIT/BLOWER MOTOR PARTS
Figure 38
102. 101688 Screw, #8 x 1/2” PTH
103. NGC-1081 Cover, Motor
104. 100906 Nut, 1/4”-20, Flange
105. NGC-1025 Assy, Blower Motor
106. NGC-3007 Kit, Fan Blade
107. NGC-1024 Sealing Block, Blower
108. NGC-1023 Clamp, Blower Seal
109. 101688 Screw, #8 x 1/2” PTH
110. NGC-3011 Heater, Convection
111. 100443 Controller, Motor
112. NGC-3005 Relay, K4/K5 SSR
113. 100592 Fuses, F1 and F2 (12 Amp)
114. 102075 High-Limit Thermostat
115. NGC-1043 Gasket, Convection Heater
* If entire motor is needed, order NGC-1025.
If only hardware (e.g., screws, nuts) or seal is
needed, call 800.90
TURBO or +1 214-379-6000.
** Not shown for clarity.
Assembly Notes
1. Cut insulation covering heater as shown.
FIGURE 38: Convection Circuit Assembly and Parts/Item 105 (Blower Motor) Detail
*
**
111
x6
113
112
102
103
104
105
109
110
114
x8
x10
1
1
THE CONVECTION CIRCUIT
48
106
108
107
*
*