Vulcan-Hart SG4C ML-114876 Convection Oven User Manual


 
— 7 —
Assembling the Legs to the Oven
The legs must be installed on the bottom of the oven. Position oven on its back, taking care not to
scratch or damage it. The gas pipe connection protrudes beyond the back; provide for this when the
oven is tipped back by resting it on suitable spacers (2 x 4's [51 x 102 mm], etc.).
Attach each of the four leg assemblies to the bottom of the oven with the 24 bolts and lockwashers
(6 per leg). Carefully raise the oven to its normal position.
Assembling the Stand to the Oven
Attach each of the four leg assemblies to the bottom of the oven with the 24 bolts and lockwashers
(6 per leg). Carefully raise the oven to its normal position.
Attach the undershelf to the legs with 8 bolts and lockwashers (2 per leg).
Install the rack guides into the shelf at desired locations (for pan or flat rack), then attach the rack
supports to the top end of the rack guides. Attach rack supports to the leg assembly by removing one
middle bolt and reattaching back through the end holes in the rack support. (Fig. 2)
Fig. 2
BACK
FRONT
PL-52821