Filter
Top Products
Display messages
Messages will appear on the display to guide you
with your cooking. lf you attempt to enter
unacceptable instructions, ‘Erf will appear in the
Display. Touch CANCEL and re-enter the
instructions.
Audible signals
Audible signals are available to guide you when
setting and using your oven. A programming tone
will sound each time you touch a pad. Two tones
will sound between cydes. Three tones signal the
end of a Cook or Defrost cycle. ff you do not hear
a tone, it is because of incorrectly entered
instructions.
Setting the clock
When the oven is first plugged in, a tone sounds
and the Display shows ‘12:Oooo”. lf the electric
power ever goes off, the Display will again show
‘12:oo” when the power comes back on.
You can cook without setting the clock, but the
Display will show ‘12:OoOg (plus the hours,
minutes and seconds that have elapsed since the
oven was plugged in).
1.
To set the clock, touch CLOCK SET. The
Display will show ‘12:Oooo” (if time of day has
not been set before) or the time previously set.
The colon will disappear.
2. Touch Number Pads for the correct time of
day. The Display will show what numbers you
touched
in the order you touched them.
This
example shows 325.
3. Touch CLOCK SET. The colon will appear
without blinking and the seconds (in small
display on the right) count up. The Clock is
set.
lf you have touched in an incorrect time,
such as 12:65, ‘Erf will show on the Display.
Touch CLOCK SET and start over.
NOTE: To Lbsdt the clock, touch CLOCK SET.
The current time will show on the
Display and
the
colon will disappear. Continue to set the clock as
shown above.
Using CANCEL
Touch CANCEL to:
l
Erase instructions if you make a mistake during
programming.
l
Cancel the Minute Timer,
l
Stop the oven temporarily during cooking.
NOTE:
The oven may also be stopped during a
cyde by opening the door. Close the door and
touch START to restart.
11