Filter
Top Products
Chapter 1 13
Installation and Setup
Turning on the Analyzer for the First Time
Installation and Setup
Turning on the Analyzer for the First Time
❏ Plug in the power cord.
WARNING If this product is to be energized via an external auto
transformer for voltage reduction, make sure that its common
terminal is connected to a neutral (earthed pole) of the power
supply.
CAUTION The analyzer is shipped with a a transportation disk inserted in the
disk drive to prevent damage to the disk drive during
transportation. This transportation disk, or a blank floppy disk,
should be inserted in the disk drive whenever transporting the
analyzer.
Do not leave a disk in the front-panel disk drive while turning the
analyzer on. Also, ensure that the transportation disk is removed
from the drive.
NOTE Do not connect anything else to the analyzer yet.
❏ Press the power switch (located in the lower left-hand corner of the
analyzer’s front panel) to turn the analyzer on. See “Front Panel
Overview” on page 24.
NOTE The instrument requires >2 minutes to power-on.
Information
Screen
An information screen appears during the initialization process. The
information screen contains the analyzer product number and a URL
for accessing product support information on the World Wide Web. See
“Additional Information” on page 2.
NOTE The information screen displays for approximately 10 seconds before
the initialization process is complete.
Record the firmware revision and serial number, and keep it for
reference. If you should ever need to call Agilent Technologies for
service or with any questions regarding your analyzer, it will be helpful
to have this information readily available. You can also obtain the
firmware revision and serial number by pressing
System, More, Show
System.