Filter
Top Products
Chapter 4 53
Viewing Catalogs and Saving Files
Saving a File
t\
Viewing Catalogs and Saving Files
Saving a File
You can save files (setups, states, traces, limits, corrections,
measurement results, or screens) to a floppy disk (A:\), or the internal
drive (C:\). In this example you will save a trace to the internal C:
drive.
NOTE Trace files are not bitmap files. Files saved as Trace cannot be imported
into other applications or converted. If you require the use of other
applications, for example Microsoft® Word or Microsoft® Excel, be sure
to save your files as .gif or .wmf formats using Screen for your file Type.
Step 1. Set up the analyzer trace
1. Perform a factory preset by pressing Preset, Factory Preset (if
present).
2. Turn on the internal 50 MHz alignment signal of the analyzer as
follows:
• Press Input/Output, Input Port, Amptd Ref.
3. Set the center frequency to 50 MHz by pressing press FREQUENCY,
Center Freq, 50, MHz.
4. Set the span to 75 MHz by pressing SPAN, Span, 75, MHz. The
reference signal will appear on the display.
5. View trace 1 and put it into maximum hold by pressing View/Trace,
Max Hold. (Trace 1 should already by underlined, but if not, press
Trace 1 2 3 until 1 is underlined and then press Max Hold.) Your
analyzer display should look similar to Figure 4-3.