Filter
Top Products
40 Chapter 3
Making a Basic Measurement
Viewing a Signal
Making a Basic Measurement
Viewing a Signal
1. Press Preset. If the softkeys Factory Preset and User Preset appear,
select
Factory Preset.
2. Press System, Reference, then note the 10 MHz Out setting. If Off is
active (underlined), press the softkey to toggle the reference on.
3. Connect the analyzer’s rear panel 10 MHz OUT (SWITCHED) to the
front-panel input.
Setting Reference Level and Center Frequency
NOTE The display examples in this section are made using various analyzer
models, you may see some variations depending upon your analyzer.
4. Set the reference level to 10 dBm: Press AMPLITUDE, 10, dBm.
5. Set the center frequency to 30 MHz: Press FREQUENCY, Center
Freq
, 30, MHz.
The 10 MHz reference signal spectrum appears on the display, as
shown in Figure 3-1.
NOTE The display examples in this book are made using various analyzer
models, you may see some variations depending upon your analyzer.