Filter
Top Products
CY4672 Reference Design Guide, Document # 001-16968 Revision ** 25
WirelessUSB™ Protocol 2.2
2.3.5 Ping Packet (Bridge)
Byte 1
Packet Type: 3
Flag (F): This is a 1-bit field that specifies a ping or ping response (0 = Ping, 1 = Ping Response).
2.3.6 Data Packet/Back Channel Data Packet (Bridge and HID)
Data packets are sent from the HID to the bridge in connected mode. They are also sent from the
bridge to the HID in connected mode if there is an asynchronous back channel.
Byte 1
Data Packet Type:
4 = Data Packet type
5 = Back Channel Packet Type
BCDR: This is a 1-bit field used to request back channel data. Setting this bit indicates to the bridge
that the HID will be listening for data following the transaction.
Data Toggle Bit: This is a 1-bit field that is toggled for each new data packet. It is used to distinguish
between new and retransmitted packets.
Data Device Type 0/1: This is a 2-bit field that specifies a vendor-defined device type. This allows the
bridge to determine HID type. The two bits are swapped in order to be backward compatible. In most
cases the data device type is the same as the device type in the bind request and connect request.
However, they may differ when one device tries to simulate the other device, for instance, the key-
board simulates the mouse.
DT0=0, DT1= 0 Presenter (0x0)
DT0=1, DT1= 0 Undefined (0x1)
DT0=0, DT1= 1 Keyboard (0x2)
DT0=1, DT1= 1 Mouse (0x3)
Byte 2-N
Data Byte 0–N: This is byte-aligned application data.
Byte 1
Bits: 7:4 3:1 0
Field: 3 Reserved Flag
Byte 1 2 .. .. N
Bits: 7:4 3 2 1 0 7:0 7:0 7:0 7:0
Field: 4 / 5 BCDR Toggle DT0 DT1 Byte 1 Byte N
[+] Feedback