Filter
Top Products
INSTALLATION OPERATION MANUAL GARLAND ELECTRIC CLAMSHELL BROILER, CXBE12-1 MODEL
Part #4600670 - 2/15
Page 16
LATCH SYSTEM INTERNAL OPERATION - B, LATCHING
HOT SURFACE
Grill Temperatures
Will Cause Severe
Burns
PPE
Approved Personal
Protective Equipment
Must be worn
How to latch the top grate to cowl assembly.
While pulling the knob, with the other hand lift up the
upper grate, (as shown in gure #4).
Note: Ensure the upper grease shield is in the right
place aligning the two notches as shown above.
Pull
Figure #4 shows the grate being moved up to latching
position.
Push
Figure #5 shows the latch system passing through safety
lock area.
Push knob until latch passes through the safety lock
and into the locking position. The grate may have to be
moved slightly up/down.
Figure #6 shows the latch completely latching the grate
to the cowl assembly. Turn knob approximately 5 turns,
until you feel resistance.
Important note: Hand support should be maintained
until the grate is fully locked in place, to prevent the
sudden drop of the grate assembly.
How to check:
Knob should be turned
clockwise only nger tight.
Ensure the bracket is tight,
in place and there is no
gap on either side of the
bracket.
Incorrect:
Grate not in place, front side too low compared to rear
side.
Correct:
Grate in place, with consistent gap.