Filter
Top Products
INSTALLATION OPERATION MANUAL GARLAND ELECTRIC CLAMSHELL BROILER, CXBE12-1 MODEL
Part #4600670 - 2/15
Page 26
CLEANING AND MAINTENANCE, continuation
29. Sanitize all exterior broiler surface
• Wring out a clean, sanitized towel well and
spray with sanitizer.
• Wipe all exterior surfaces.
• Leave sanitizer on surfaces for at least 15
seconds to kill any remaining bacteria.
• Turn towel over and wipe surface again to
remove excess sanitizer.
• Clean the control screen only with a damp soft
cloth.
30. Reinstall parts
removed for cleaning,
after they have air-
dried.
Note: the next following steps 31 through 35 are
for unit with exhaust fan only.
31. Press the
GREEN
button to lower
upper platen; Turn
the clamshell broiler
Main Power Switch
OFF (Green Main
Power switches are
set at the OFF: “0”
position).
32. Remove the three
(3) thumb screws
located around the
motor.
Important: Be gentle
with the electrical
conduit when
removing motor,
electrical conduit is
not designed to be
disconnected. Do not
attempt to disconnect
the motor conduit.
33. Lift up the motor, and spray blower wheel
with degreaser solution. It is recommended
to perform cleaning over a towel/rug/paper
for easy disposal of the falling debris. Rest the
upper blower assembly safe with all other parts
are cleaned and returned.
34. Remove exhaust
tray, wring out a
clean, sanitized
towel and spray
with degreaser
solution. Turn towel
over and wipe
surface to remove
grease.
35. Spray the exhaust tray and housing with
degreaser solution. They can be cleaned in the
sink to remove grease/debris.
36. Place exhaust tray,
housing & motor in
place and tighten
the (3) thumb
screws manually by
hand.