Filter
Top Products
7
Your range, like many other household items, is heavy and can settle into soft floor coverings such as cushioned
vinyl or carpeting. When moving the range on this type of flooring, use care, and it is recommended that these
simple and inexpensive instructions be followed.
Installing
The range should be installed on a 1/4 inch thick sheet of
plywood (or similar material) as follows:
When the floor covering ends at the front of the range,
the area that the range will rest on should be built up
with plywood to the same level or higher than the floor
covering. This will allow the range to be moved for
cleaning or servicing.
Leveling
Leveling screws are located on each corner of the base
of the range. Remove the bottom drawer and you can
level the range on an uneven floor with the use of
a nutdriver or channel locks.
To remove the drawer, pull the drawer out all the way,
tilt up the front and take it out. To replace the drawer,
insert glides at back of the drawer beyond stop on the
range glides. Lift drawer if necessary to insert easily.
Let the front of drawer down, then push in to close.
One of the rear leveling screws will engage the Anti-Tip
device. Allow for some side to side adjustment. Allow
a minimum clearance of 1/8″ between the range
and the leveling screw that is to be installed into the
Anti-Tip device.
PREPARATION
READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.
SAVE THESE INSTRUCTIONS