Filter
Top Products
7
TroubleshootingBefore Use Operation Cleaning
z
Preventing ajar doors
z
Adjusting a tilted door or unevenness
z
If the door is still tilted after adjustment of the supports
z
Installing the support cover
Insert the support cover horizontally
and fully, until it makes contact with
the rear side.
Do not damage or drive screws into
the refrigerant circuit (pipes).
Prepare for earthquakes.
Support cover
The support cover is stored
inside the refrigerator
compartment at shipment.
4
Adjustment and anchoring
Turn the adjustable supports until they touch the fl oor and
the front casters are raised from the fl oor.
3
Adjust the supports to
make the refrigerator
level.
If the front of the
refrigerator is slightly
raised, the doors are
easier to close.
When installing the refrigerator in
the corner of a room, one of the
rear supports may sink, causing the
refrigerator to tilt. If this happens, use
a caster support (sold separately) or
strong board for adjustment. (Normally,
use a board with a thickness of about 2
to 3 mm.)
To purchase a caster support, contact the retail
store where you purchased the refrigerator.
Model: MRPR-03CS
Readjust the adjustable supports as
shown in the fi gures below.
The right door tilts down
Raise the right side
Right Left
The left door tilts down
Support
cover
Adjustable
support
Caster
Raise the left side
Rear support
Caster support or
strong board
If the installation
location is not level or
the supports sink after
a few days due to the
weight of the food,
the doors may appear
tilted.
Readjust the supports.
(Depending on the
volume stored, more
than 100 kg of food
can be stored in the
refrigerator.)
Although fl ammable refrigerant is used, the refrigerant circuit
is hermetically sealed and normally leaks will not occur.
Should the refrigerant circuit be damaged:
1. Do not use fl ames or electrical appliances nearby.
2. Open the windows to fully ventilate the room.
Then, contact the retail store where you purchased the refrigerator.
Strong belts
Pass 2 strong belts through the hand-holds on the top rear of the
refrigerator and anchor them to a strong location, such as wall or post.
To obtain the refrigerator tipping prevention belts (sold separately),
contact the retail store where you purchased the refrigerator.
Model: MRPR-02BL
The refrigerator may tip over
and cause injury.
Adjustable
support
Caster
Turn the adjustable
supports in the arrow
direction until they
touch the fl oor.
Support cover
(To prevent vibration, noise, movement, and ajar doors)
Bottom front of refrigerator
Warning
Warning
If the supports are not
adjusted properly, the
refrigerator may move
and cause injury.
Caution