Filter
Top Products
14
In the prompt line is equivalent to the “End” key.
On a program line means the program is locked; it
can be copied and then edited but not edited
directly.
Up arrow
Down arrow
Enter
Pause
The following terms are used when programming the CYCLER TCY:
Stage
A ‘Stage’ is the name given to the main repeated part of a program
containing the ‘Steps’ to be repeated. A program can contain a maximum
of 25 stages although typically only one or two are used.
Cycle
A ‘Cycle’ is the number of repetitions of a ‘Stage’
Step
A ‘Step’ is a user defined program line containing a temperature, a hold
time and ramp rate. Typically three steps are created within one ‘Stage’.
To enter the programming section of the
Cycler TCY software, highlight ‘methods’
using the “Up Arrow” or “Down Arrow” keys
Press “Enter”
This screen lists all the programs saved on
the unit. Use the “Up Arrow” and “Down
Arrow” keys to scroll through the list.
The number next to the program name is the
unique “Speed dial” number allocated to the
program for rapid retrieval (see below).
Programs [0]
Information
Configuration
[ , to select ]
Methods [0]
Information
Configuration
[ , to select ]
* * New program ** []
2 STEP TEMPLATE 501
3 STEP TEMPLATE 502
[ , to select ]
* * New Methods ** []
2 STEP
3 STEP
[ , to select ]