Filter
Top Products
19
To copy a selected program
If you select ‘Copy program’ a screen
similar to this will appear and the software
will automatically give the program the
next number until it is named.
Press “Enter” and type in a new name.
You will then be able to edit the program
as previously described.
To delete a selected program
If you select ‘Delete program’ a screen
similar to this will appear.
Press “Enter” to delete the program or
“End” to return to the program screen.
To set a password for a selected program
If you want to password protect the
program so that other users cannot edit it,
select ‘Set password’. A screen similar to
this will appear.
Type in the password you wish to give it
and press “Enter” . The program list
will then display the key symbol next to
the name to show that it is locked.
Other users will still be able to copy/view
your program but not edit it.
Option 2: Creating a new program
A second option is to create a completely new program without using templates.
A number of typical values are pre-entered
including:
Heated lid temperature
Preheat lid
Initial denaturation
Hot start
Final extension
Final hold
These values can be edited and the
additional stages and steps required for
cycling can be added by following the
instructions detailed on the following
pages.
UNNAMED #
Heated lid 105ºC
Preheat lid off
Pause off
-
- - - - - - - - - -
In denat
94.0 º C 5m00
Hot Start off
-
- - - - - - - - - -
Fin extn
72.0 º C 5m00
Fin hold 10.0
º
C
UNNAMED #
Heated lid 105ºC
Preheat lid off
Pause off
-
- - - - - - - - - -
In denat
94.0 º C 5m00
Hot Start off
-
- - - - - - - - - -
Post run
72.0 º C 5m00
Post hold 10.0
º
C