Filter
Top Products
30
Access to the ‘Configuration’ set up is
password protected.
Default admin passwords is 1234
To enter configuration, use the alpha keys
to type in ‘1234’
Press “Enter”
There are a number of options which can
be changed; these are listed here.
Use the “Up Arrow” and “Down Arrow”
keys to select then press “Enter” to
access any of the options. Each option is
discussed in detail below.
Settings
Settings
Highlight ‘Settings’ then press “Enter”
Highlight ‘Settings’ then press “Enter”
The complete list of settings is given here.
Auto restart “on” will allow the unit to
restart from where it left off should there
be a power failure and the power returns.
The “Comms address” refers to the
location of a unit in a daisy chain and
must be unique if there are several units
linked to each other.
The optimum “Coms speed” is set at
19200. When using a control software,
ensure all cyclers are set to the same
value.
Edit any line as described for ‘Program
defaults’ above. Press “Enter” to
accept the new value.
Program defaults
Settings
Passwords
Controller reset
Settings
Passwords
Format memory
Self-calibrate
Program defaults
Settings
Passwords
Controller reset
Settings
Passwords
Format memory
Self-calibrate
Set date xx/xx/xx
Set time xx:xx
Date format
d
my
Auto restart on
Beeper on
Coms
address 1
Coms
speed 4800
[ , to select ]
Set date xx/xx/xx
Set time xx:xx
Date format
d
my
Auto restart on
Beeper on
Coms
address 1
Coms
speed 4800
[ , to select ]
Set date xx/xx/xx
Set time
xx:xx
Auto restart on
Beeper on
Coms address 1
Coms speed 192
0
0
[ , to select ]
Program defaults
Passwords
Controller reset
Passwords
Self-Calibrate
Format memory
Settings
1234