Filter
Top Products
32
Trouble Shooting Guides continued
LCD User Screen Display Information
Display Reads Problem Solution
E01 Sensor malfunction Contact Sunbeam Customer Service on
Australia 1300 881 861
New Zealand 0800 786 232
E02
E04 Pressure can not gain Remove gasket entirely from the lid. Clean
and dry and replace firmly back into the lid.
Refer to page 24 for cleaning guide.
Ensure the lid is locked on, and the pressure
valve is in the ‘SEAL’ position.
If this error occurs again, ensure the gasket
and the valves are clear from debris. Then
reset the unit.
E05 Temperature is too high. Open the lid and allow to cool. After the
message disappears, relock the lid, ensure
the valve is in the ‘SEAL’ position and reset
the program.
Dry Dry Error. There is not
enough liquid in the pan
Carefully use the finger tab on the pressure
release valve and flick to ‘RELEASE’. When
pressure has been released, carefully remove
the lid using oven mitts and add liquid to the
pan. Replace and lock lid, and ensure the
valve is in the ‘SEAL’ position.
Lid Lid Error. The lid is
locked using the frypan
menu
Do not lock the lid on the frypan menus.
Remove the lid and reset the program.