Filter
Top Products
16
Operat ing Procedu res
Model 632
Insert the drive shaft intothe freezing cylinder , hex end
first, and into the rear shell bearing until the seal fits
securely over the rear shell bearing. Engage the hex
end firmly into the drive coupling. Be sure the drive
shaft fits into the drive c oupling without binding.
Figure 4
Step 2
Take one of the scraper blades and slip it under the
hook at the fr ont of the beater . Wrap the blade around
the beater following the helix and pushing the blade
down onto thehelix as you wrap. At the back end of the
beater, slip the blade under the hook. Repeat this
step for the second scraper blade.
Figure 5
Holding the beater securely, slide the beater one third
of the w ay into the freezing cylinder. Looking into the
freezing cylinder, align thehole at the rearof the beater
with the flats on the end of the drive shaf t.
Figure 6
Slide the beater th e rem ainder of the way into the
freezing cylinder and over the end of the drive shaft .
The beater should fit snugly, but not so ti ghtly that the
beater cannot be turned slightly to engage the d rive
shaft. If the beater slides in too easily with litt le or no
resist ance, there will not be enough forc e against the
beater to hold the blades in place. If this is the case,
contact your authorized Taylor service agent.
Step 3
Assemble th e freezer door. Place the large rubber
gasket i nto the groove on the back side of the freezer
door.
Slide the white plastic front bearing over the baffle rod
onto the bearing hub making certain that the flanged
end of the bearing is resting against the freezer door.
DO NOT LUBRICATE THE GASKET OR THE
FRONT BEARING.
Figure 7