Filter
Top Products
20
Operat ing Procedu res
Model 632
If blades are i ngood condition, installthe scraper blade
clips on the scraper blades. Place the rear scraper
blade over the rear holding pin on the beater (knife
edge to the outside). Holding the rear blade on the
beater, slide the assembly into the freezing cylinder
halfway, tail end first . Install the fr ont scraper blade
over th e fr ont holding pin. Slide the beater assembly
completely into the fr eezing cylinder.
Figure 22
Step 3
Install the draw valve. Slide the two o- r ings into the
grooves on the draw valveand lubricatethe bottom 1/2
of the valve.
Figure 23
Lubricate the inside of the freezer door spout, top and
bottom, and insert the draw valve into the freezer door
from the top. It will be necessary to rotate the draw
valve to the right when assembling the door to the
freezer .
Figure 24
Step 4
Inst all the freezer door. Place the fr eezer door gasket
into the groove on the back of the fr eezer door. Slide
the fr ont bearing over the baffle rod so the flanged
edge is against the door. DO NOT LUBRICATE THE
GASKET OR BEARING.
Figure 25
Insert the baffle rod through the beater in the freezing
cylinder. With the door seated on the freezer studs,
install the stud nuts. Tighten equally in a criss- cross
pattern to insure the door is s nug.
Figure 26