Taylor 632 Freezer User Manual


 
19
Model 632 Operat ing Procedu res
Step 9
Lay the air tube (with the air orifice installed) in the
bottom o f the mix hopper for sanitizing.
Note: The air tube for theshake side does not require
o- rings or an air orifice.
Freezing Cylinder Assembly -
Shake Side
Note: When lubricating part s, use an approved food
grade lubricant (example: Taylor Lube).
MAKE SURE CONTROL SWITCH IS INTHE
“OFF ” POSITION. Failure to do so may cause injury
from hazardous moving parts, or elect rocution.
Step 1
Install the dr ive shaft. Lubricate the groove and shaft
portion that comes in contact with the bearing on the
beater drive shaft. Slide the seal over the shaft and
groove until it snaps into place. DO NOT lubr icate the
hex end of the drive shaft. Fill the inside portion of the
seal with 1/4” more lubricant and lubricate the flat side
of the seal that fits onto the rear shell bearing.
Figure 19
Insert the drive shaft intothe freezing cylinder , hex end
first, and into the rear shell bearing until the seal fits
securely over the rear shell bearing. Engage the hex
end firmly into the drive coupling. Be sure the drive
shaft fits into the drive c oupling without binding.
Figure 20
Step 2
Install the beater assembly. First check the scraper
blades for any nicks or signs of wear. If any nicks are
present, replace the blade(s).
Figure 21
Note: To prevent costly damage, the hole on the
scraper blade must fit securely over the pin.