Filter
Top Products
Thermador®
Thermador ESC30 and GSC30 30 inch range error codes
Error Codes
F6
Causes
Missing APPLIANCE
CHASSIS line cycle
detector
Example
If 60 cycles is missing for one
minute
Corrective Action
Cancel key will reset
F7
Function key stuck or
shorted
Stuck key
Must power down to clear this error. If key
remains stuck, replace clock assy.
F8 Analog/Digital supervisory Will cancel cook mode
Reset with cancel key, if persists, replace clock
assy.
F9 Door latch supervisory Will cancel clean mode Check door latch if latch is OK, replace clock.
Note 1 Oven sensors should measure 1050
ohms at 75 degrees F. if the sensor
measures correctly (within 10%),
check each leg of the sensor to
ground and to each phase of the
electrical supply. If all checks OK,
check the contacts inside the molex
plug. If the spring contacts are bent
or crushed, the sensor will create
intermittent errors.
20