Filter
Top Products
B
WFR 2460 Washer Fault Codes
T1: Error (error displays).
The last 8 fault codes are stored & displayed!
Er: 08 Heating time exceeded After 105 min. Start T/P18 heater test
programme
Er: 09 Uncontrolled motor
acceleration
Motor triac defective Start T/P4 motor test
programme.
Er: 10 Motor does not rotate No / incorrect tacho-
generator signal
Start T/P4 motor test
programme.
Er: 11 Reversing relay test
not passed
Start T/P4 motor test
programme.
Er: 12 Flow rate sensor
detects low water level
Sensor / line Check line
Replace sensor
Er: 13 Water inlet time
exceeded
Water inlet / sensor Start T/P11 sensor
test programme
Er: 14 Water inlet time
exceeded
W controller after 6
min.
Start T/P9 controller
test programme
Er: 15 Pumping time
exceeded
0 level not reached
within 6 min.
Check pump circuit
Er: 16 Safety level reached Start T/P8 and 9 level
test programme
Er: 17 Pressure sensor Check line
Replace sensor
Er: 18 Calibration of pressure
sensor not possible
Start T/P8 level test
programme
Er: 19 Aqua stop fault Aqua stop actuated Eliminate leaks
Er: 20 Turbidity sensor Calibration not
possible
Start T/P10 sensor
test programme
Er: 21 Update
Er: 22 Spin cycle terminated After 15 start-up
attempts
Start T/P4 motor test
programme
Er: 23 Foam detected Via analogue sensor Consult customer
about dosing
The programme can be ended with the “Start / Pause” button. The errors can
be selected with the “Menu” button. Only the errors of the last 8 wash
programmes are stored and displayed.
Sequence:
Time/Operation Display Note
HINTS: # of errors
reads “0” for faults
which didn’t occur.
Look at # of errors,
not error #, to see if
faults occurred.
Number of errors Error #
The error frequency is
displayed on the lower line
and the error number on the
right.
Hint:
Scroll thru all errors to
check if any occurred.
>>MENU T1: ERRORS
7- Er : 12
Display Error Possible Cause Remedial action
Er: 01
Door open Door switch not actuated Close door, check lock
Er: 02
Door lock cannot be
released
Er: 03
Door lock cannot be
locked
Er: 04
Door actuation
defective
Triac defective / relay
stuck
Replace controller
Er: 05
NTC interruption Cable break / NTC
damaged
Rectify cable short –
circuit / replace NTC
Er: 06
NTC short-circuit Cable short-circuit / NTC
damaged
Rectify cable short-
circuit / replace NTC
Er: 07
Unexpected heating Temperature increase
without actuation of
heater
Start T/P 18
heater test
programme
42