Filter
Top Products
Mechanical
Specifications
UNT-PRC001-EN60
Disconnect Switch
A unit mounted disconnect switch is
available as a standard option on all
units.
Colors
Six decorator colors are available in a
baked powder finish. For a color chart,
contact your local Trane office for a copy
of UNT-S-10.
Extended End Pockets
On vertical or horizontal cabinet units, an
8” (20 cm) extended end pocket is
available on the piping end.
Tamperproof Locks
Key-operated locking access doors and/
or panels will help prevent nuisance
tampering with unit and/or controls.
Tamper proof locks are available on
vertical cabinet, horizontal cabinet,
vertical recessed, vertical slope top, and
low vertical units.
Leveling Feet
Refrigerator type screw-in bolts to level
the unit are available on vertical and low
vertical cabinet units.
Options
Quad Grille Outlet
Quad grilles are square multi-directional
grilles that allow four different discharge
directions by rotating the grilles 90
degrees. The quad grille is constructed of
a black plastic material (NORYL-SE 1-731)
with a 15 degree angle on the discharge
louvers. Quad grilles are recessed into
the discharge panel to prevent condensa-
tion from forming on the grille exterior.
Quad grilles are available on all cabinet
style units.
Bar Grille Inlet/Outlet
Bar grilles are formed steel grille options
available on the discharge of all cabinet
units, the return of vertical cabinet,
vertical slope tops and low vertical
cabinet units. The grilles have a black
paint finish with 18-gauge steel construc-
tion. The louvers are formed at a 15
degree angle, and the discharge grilles
are recessed to prevent condensate
formation on the surface of the grille. The
bar grilles are fixed in one discharge
direction.
Sub-bases
Sub-bases elevate vertical cabinet or
slope top cabinet units to a specified
height; for example, to reach the bottom
of a window sill. The sub-base also
provides a cavity through which to run
piping underneath the fan-coil unit. Sub-
bases are 16-gauge steel construction
and have the same black paint finish as
the unit’s base. The sub-base is available
in heights between 2 - 7” (5 -18 cm) in
1
/
2
” (1 cm) increments. The sub-base
depth and width is identical to the unit’s
dimensions.
Quad Grille Outlet
Bar Grille Inlet and Outlet
Sub-base (shown turned on its side)