Filter
Top Products
Introduction
206380-A
1-3
15-Pin Connector
The standard 15-pin connector on the other end of the BayStack 22 PC Card
Adopter (Figure 1-1
) attaches to the 15-slot connector on the media coupler.
Media Coupler
The media coupler (Figure 1-2
) provides connection to the BayStack 22 PC Card
Adopter and to Ethernet network devices. Three LEDs located on the media
coupler indicate 10 Mb/s or 100 Mb/s transmission speed and connection stability.
Figure 1-2. Media Coupler
The 15-slot connector on the media coupler attaches to the 15-pin connector on
the BayStack 22 PC Card Adopter. The other end of the media coupler contains an
RJ-45 port. You can attach a standard Ethernet cable to the RJ-45 port to connect
the network card to a network device such as a hub or switch.
RJ-45 Ethernet Port
The RJ-45 10BASE-T/100BASE-TX Ethernet port adapts to the correct network
speed of 10 Mb/s or 100 Mb/s through autonegotiation with the board components
of the network card. The port is wired as an MDI-X port to connect to other
devices without using a crossover cable.
9476FA