Filter
Top Products
Novell NetWare Reference Information
206380-A
B-3
The following are examples of typical FRAME parameters:
LOAD B22LAN10 FRAME=ETHERNET_802.2
LOAD B22LAN10 FRAME=ETHERNET_802.3
LOAD B22LAN10 FRAME=ETHERNET_II
LOAD B22LAN10 FRAME=ETHERNET_SNAP
INT Parameter
The INT parameter refers to the interrupt (IRQ) value used by the BayStack 22
network card. The INT value must match the IRQ value you specify when
enabling the B22ENA10 program. You must use a DOS prompt to enable this
program before you access your Novell NetWare 4.x server. Refer to “Installing
the Network Card in a Novell NetWare Server” on page 3-32 for instructions.
The following is an example of a typical INT parameter:
LOAD B22LAN10 INT=3 FRAME=ETHERNET_802.2
PORT Parameter
The PORT parameter reflects the input/output (I/O) port address of the server.
The PORT value must match the IOP value you specify when enabling the
B22ENA10 program. You must use a DOS prompt to enable this program before
you access your Novell NetWare 4.x server. Refer to “
Installing the Network Card
in a Novell NetWare Server” on page 3-32 for instructions.
The following is an example of a typical PORT parameter:
LOAD B22LAN10 INT=3 PORT=300 FRAME=ETHERNET_802.2