Filter
Top Products
31
ASSEMBLING THE BLENDER
ASSEMBLING THE BLENDER
Before using the Blender for the first
time, remove and safely discard any
packaging material and promotional labels.
Ensure the power cord is unplugged from
the wall outlet.
Wipe the Motor Base with a damp cloth.
Dry thoroughly.
Wash the Lid, Inner Lid, Blender Jug,
Removable Silicone Gasket and Removable
Blade Assembly (see Disassembling the
Blender, page 37) in warm, soapy water with
a soft cloth. Rinse and dry thoroughly.
Alternatively:
• Fill the Blender Jug halfway with warm
(not hot) water and add 1-2 drops of
dishwashing liquid. Place the Blender Jug
on the Motor Base. Select speed 1/MIX
and run the Blender for 10-20 seconds.
Remove the Blender Jug and discard
the contents. Rinse the Blender Jug with
warm water until clean. Dry thoroughly.
OR
• Place these parts in the dishwasher on
a normal cycle. The Removable Silicone
Gasket and Removable Blade Assembly
should be removed from the Blender
Jug and placed on the top shelf of the
dishwasher with the Lid and Inner Lid.
The Blender Jug should be turned
upside down (with the jug spout facing
downwards) to prevent the dishwasher’s
heating element from damaging the
Blender Jug base.
1. Place the Motor Base on a flat dry
surface such as a bench top. Ensure
the power cord is unplugged from the
wall outlet.
2. With the raised rim of the Removable
Silicone Gasket facing downwards, place
the Gasket onto the Blade Assembly and
push down until it clicks into place.
WARNING
Be careful when handling the blending
blades as they are sharp. Mishandling
of the blades may cause injury.
Place raised rim downwards into Blade Assembly.