Filter
Top Products
15
OPERATING YOUR JUICE FOUNTAIN™ PLUS
1. Wash your selection of fruit and
vegetables ready for juicing.
NOTE:
Most fruit and vegetables such as
apples,carrots and cucumbers will
not need to be cut to size as these
will fit into the feed chute whole.
When juicing carrots place the tip of
the carrot into the feed chute last.
2. Ensure the Juice Fountain is correctly
assembled. Ensure the stainless steel
filter is thoroughly cleaned before each
use (refer to care and cleaning on
page 21). Ensure you place the juice
jug (or a glass)under the spout before
commencing juicing.
3. Plug the power cord into a 110/120V
power outlet. Push the two speed
switch either up for low speed or down
for high speed depending on the type
of fruit or vegetable being juiced. Use
the speed selector table as a guide for
juicing different fruits and vegetables.
NOTE:
Be sure to start the motor first
before placing any fruits or
vegetables down the feed chute.
Failure to start the motor prior, can
cause the motor to overheat.
WHEN USING THE JUICE
FOUNTAIN ON HIGH SPEED,DO
NOT RUN THE JUICER FOR
LONGER THAN 4 MINUTES AT
A TIME WHEN CONTINUOUSLY
JUICING HARD FRUITS AND
VEGETABLES, SUCH AS
APPLES,CARROTS,AND BEET.
AFTER SUCH TIME, WAIT 1
MINUTE BEFORE RESUMING
FEEDING FRUITS AND
VEGETABLES DOWN THE
FEED CHUTE.
!
JE98XL_IB_Issue1,09.indd 15 16/12/09 11:26 AM