Filter
Top Products
Software Problems
The application program does not start.
Check that you are following the correct procedure for starting
the program and that it is installed correctly. If you do not have
a hard disk, make sure the correct diskette is in the diskette
drive. If you need help, contact your software manufacturer.
The application program is having trouble reading a key
d&k.
You may be running an application that requires a slower
processor speed. Change your processor speed using the
keyboard comman
ds described in Chapter 2.
The application program is having trouble reading from of
writing to the hard disk drive.
If you have enabled the
Fixed Disk Timeout option in
SETUP, your application may be timing out during the few
second delay when the hard disk drive returns to its operating
speed after being in standby mode. Disable this option in
SETUP (see Chapter 1).
Your application has locked the computer, making it
unresponsive to keyboard commands.
Reset the computer and try again. If resetting the computer
does not help, turn it off, wait 20 seconds, then turn it on again.
Some software, like OS/2,
®
UNIX,
®
or NetWare,
®
needs a
minimum of 8MB to 16MB of RAM to work correctly. Check
your software documentation for the minimum memory
requirements. If necessary, add additional memory using the
instructions in Chapter 3.
Troubleshooting 5-11