Filter
Top Products
9. Check the settings of jumpers J11 and J13 to be sure they are
set for the type of microprocessor you installed. You may
also need to change the setting of jumper J17 to match the
microprocessor type and operating speed.
If you installed a microprocessor with a different voltage
(check the table on page 3-24), you need to change the
setting of jumper J31 and J33. See pages 3-6 and 3-7 for
information on all these jumper settings.
10. If you are upgrading to a DX/40, DX/50, DX2, DX4, SX2, or
Pentium OverDrive processor, you must install a heat sink
and/or a fan, depending on the brand of processor you
installed. See the table on page 3-24 for more information.
Follow the instructions included with the heat sink if you
need to install one. If the heat sink comes with a fan, install
it using the instructions that came with the heat sink and
fan kit.
11. Replace any option cards you removed; see page 3-15.
12. Run SETUP as described in Chapter 1 to update your
computer’s configuration with the new microprocessor.
Post-installation Procedures
After you install or remove options, you must run SETUP to
update the computer’s configuration. See Chapter 1 for
instructions. Additionally, you may need to add some
commands to your configuration files. See your operating
system manual and the manual that came with your optional
equipment.
Installing and Removing Options
3-27