Filter
Top Products
8.
Hold the connector on the ribbon cable so the red wire aligns
with pin 1 on the drive. Make sure the holes in the
connector fit over all the pins; then push in the connector.
9.
Locate a power supply cable for each drive installed in the
rear internal bay. These cables lead from the power supply
and have multi-colored wires with a plastic
connector
on
the end. Align the notched comers of the power supply
connector with the drive’s power connector; then push in
the connector.
10. If you have finished installing or removing drives, replace
the computer’s cover (described in Chapter 3) and see page
4-21 for post-installation instructions.
4-18
Installing and Removing Drives