Filter
Top Products
msTkLLAmoNmsTRucTIoNs ,
(continued)
a~o~~~~~l~~ suRFacEBURNERSON
MOBELSEQU!PPEBWITHsmLEn BURHEB (see
sP@p4 if
ramgois @quipp@dwithdualburneK.)
BurnerCap
OrificeSpud
GasInletTube
(( 1—, .
1.
Removegrates, burner caps and burner heads.
2. Removeburner bases by unscrewing the 3
small screws in each base. ~
bmner
strai&t out.
DO N~
disconnect the wires from the burner
bases unless the cooktop needs to be raised.
3. Removethe brass orificespud under each
burner base by unscrewing sp~d fi-omfittingwith
a 7mm or 5/16” wrench (depending on the size of
your spuds). Applya 3/4” wrench to the hex on
the gas inlet tube as a back-upwhen removing
spud to prevent the aluminum tube from twisting.
4. Install orifice spuds accordin to one ofthe
d
fol~owingdiagrams (see
❑ or B), for LP
gas or natural gas, depending on which you are
converting to.
42
LPorificespuds are in a small plasticbag packed
with this Use and Care book. LP orificespuds
have a 2-digitnumber and the Letter “L”on
one side, Each ofice spud willalso have 1 or 2
grooves on one side, denoting the location on
the range where it is to be installed.
w
II
w
‘Frontof.angw
Natural gas ofice spuds have a 3-digitnumber
on one side. Each orificespud willalso have 1,2
or 3 grooves on one side, denoting the location
on the range where it is to be installed.
Front of Range
D
o
‘-
D