GE JKP16 Oven User Manual


 
r--
OPEWTmG
THE SELF-CLEANING OVEN
(continued)
How to Set Oven for Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
If the oven is
too
hot and you start to
set
a clean
cycle, the word “OFF” will
appear in the display.
Allow additional time for cooling before you try
to set the cycle.
1.
Follow the directions in the Before a Clean
Cycle section.
m
2.
After closing the door, press the
AUTO SELF
CLEAN
AUTO SELF CLEAN pad.
A
3. Press the INCREASE or
DECREASE pad until the
@
desired Clean Time is displayed.
Clean Time is normally 3 hours.
w
You can change the Clean Time to
e
any time between 2 and 4 hours,
depending on the amount of soil
in your oven.
The self-clean cycle will automatically begin
after
“CLEAN” is displayed and the time for the clean
cycle is set. The words
“ON” and “LOCK” will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK light goes off.
4. When the LOCK light is off, open the door.
NOTE:
The
word
“door” will be displayed, the word
“LOCK” will
flash
and oven control
will
signal
if you set
the
clean cycle and forget to close the
oven door.
A fan may automatically turn on and off to cool
internal parts., This is normal and the fan may
continue to run even after the oven is turned off.
(—)
YOU
can find out when the clean cycle
STOP
will be finished by pressing the STOP
TIME
TIME pad.
A
To Stop a Clean Cycle
o
1.
Press the CLEAWOFF pad.
2. When the LOCK light goes off and the oven
CLEAR
has cooled below the locking temperature, open
OFF
the door.
30