Filter
Top Products
OVEN CONTROL, CLOCK AND
TMER
.ock
The clock must be set
for
the automatic oven timing
functions to work properly. The time of day cannot be
changed during
a
Timed
Baking
or Self-Cleaning cycle.
To Set the Clock
(
1.
Press the CLOCK pad.
u
CLOCK
A
A
2. Press
the
INCREASE or DECREASE
pad to set the time of day.
@
v
w
3. Press the CLOCK pad to
start.
Timer
To Set the Timer
The timer is a minute timer; it does
n
1. Press the TIMER
The timer will start automatically
not control oven operations. The
TIMER
ON/OFF pad.
within a few seconds of releasing the
maximum setting on the timer is 9
ON/OFF
INC~ASE
or DECREASE pad. The
hours
and
55 minutes.
&
timer, as you are setting it, will display
A
2. Press the
seconds until one minute is reached.
1~lCREASE
or
Then it will display minutes and
@
DECREASE pad to
seconds until 60 minutes is reached.
set the amount of
After 60 minutes, it will display hours
time on the timer.
(“HR” now appears in display) and
v
@
minutes until the maximum time of
9 hours and 55 minutes is reached.
To Reset the Timer
To Cancel the Timer
If “TIMER” is displayed, press the INCREASE or
DECREASE pad until desired time is reached.
Press
find
hold the TIMER ON/OFF pad until the
word “TIMER” disappears from the display.
If “TIMER” is not displayed, press the TIMER
ON/OFF
pad
first, then follow the instructions above
to set the timer.
End
of
Cvcle
Tone
Power Outage
v
The end of cycle tone is
a
series of three beeps
After a power outage, when power is restored. the
followed by one beep every six seconds until you
display will flash and time shown will no longer be
press
any
operation. If you would like to eliminate the
correct-for example, after a 5-minute power
repeating beeps,
press
and
hold the CLEAR/OFF pad
interruption the clock will be 5 minutes slow.
‘“or
I
() seconds.
The display flashes until the clock is reset.
Ail
other
o return the end of cycle tone to the repeating beeps,
functions that were in operation when the power went
press
and
hold the CLEAR/OFF pad for
10
seconds.
out will have to be programmed
a&ain.
([orltitlLfl,(l
11(,.Y1
[)cl<q(’
7