Filter
Top Products
REMOVAL AND REPLACEMENT OF PARTS
Due to use of chemical detergents, all interior replacement hardware must be stainless steel hardware
as listed in the parts catalog.
COVERS
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
Pump Cover
1. Remove two thumbscrews securing pump cover
and lift cover off.
2. Reverse procedure to install.
NOTE: Anytime service is performed requiring the
right side cover to be removed, check to ensure
incoming power terminal block wire retaining screws
are tight.
Right Side Cover
1. Remove Pump Cover.
2. Remove twelve screws securing right side cover
to frame.
3. Loosen one screw securing top center of cover.
Fig. 17
4. Remove cover.
5. Reverse procedure to install.
Left Side Cover
1. Remove ten screws securing left side cover to
frame.
2. Loosen one screw securing top center of cover.
Fig. 18
3. Remove cover.
4. Reverse procedure to install.
Top Cover (Control Panel)
1. Remove screws securing top cover over controls
area.
2. Remove cover.
3. Reverse procedure to install.
Top Cover
1. Remove screws securing Top Cover (Control
Panel).
2. Remove cover.
3. Remove remaining screws securing top cover
and lift cover off.
KA SERIES ELECTRIC ROTARY OVENS - REMOVAL AND REPLACEMENT OF PARTS
F25294 Rev. A (0412) Page 10 of 72