Filter
Top Products
4. Water is injected into the sump until level reaches
probe. This "fill time" will then be used for all
subsequent fill cycles.
5. Once water is sensed at the probe, the wash
pump turns ON and rinsing begins. This normally
lasts for 2 minutes. (can be programmed by P36)
6. After rinsing is complete, the drain pump turns
ON for 3 minutes. (can be programmed by P33)
7. After drain pump is complete, the drain peristaltic
turns ON for 3 minutes (if installed on machine).
8. Cycle now complete.
9. Wash: Now the machine is ready to wash.
10. Fill sump with water based on "fill time"
determined during Pre-Rinse.
11. Chemical injected for 40 seconds. (can be
reprogrammed in P31)
12. Begin washing. Wash pump ON for 4 minutes
(can be reprogrammed in P48) and OFF for 4
minutes (can be reprogrammed in P49).
13. Washing lasts for 120 minutes. (can be
reprogrammed in P34)
14. After washing is complete, the drain pump turns
ON for 3 minutes. (can be programmed in P33)
15. After drain pump is complete, the drain peristaltic
turns ON for 3 minutes (if installed on machine).
(can be programmed in P33)
16. Wash cycle complete.
17. Post-rinse: The number of post-rinse cycles is
factory set at 2. (can be programmed in P35)
18. Fill sump with water based on "fill time"
determined by Pre-Rinse.
19. After filling with water, the wash pump turns ON
and washing begins. This normally lasts for 2
minutes.
20. After rinsing is complete, the drain pump turns
ON for 3 minutes.
21. After drain pump is complete, the drain peristaltic
turns ON for 3 minutes (if installed on machine).
22. Cycle now complete.
23. Drying Mode: After the post rinse cycles are
complete, the software enters the Drying Mode
for 10 minutes.
24. The machine heats to 250°F (can be
programmed by P43). If drying time is set to 0,
the drying mode is skipped.
25. Cleaning is complete.
CONTROLS EXPLANATION
Model KA7E
KA SERIES ELECTRIC ROTARY OVENS - ELECTRICAL OPERATION
F25294 Rev. A (0412) Page 48 of 72