Filter
Top Products
APPENDIX
REVERSING CONTROLS
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
NOTE: Rotor on/off switch position does not get
changed.
1. Remove Right Side Cover.
2. Disconnect wires from power switch.
3. Squeeze tabs on bezel and pull switch and bezel
out of hole.
Fig. 135
4. Unplug ribbon cable from display board.
A. Spread retaining clips to extract plug from
socket.
Fig. 136
5. Remove six nuts securing display panel with
display board attached and lift out of oven.
Fig. 137
KA SERIES ELECTRIC ROTARY OVENS - APPENDIX
Page 69 of 72 F25294 Rev. A (0412)