Filter
Top Products
Fig. 46
12. Remove o-ring from old fan motor shaft and
install on new fan motor. If not in good condition,
install new o-ring.
Fig. 47
13. Reverse procedure to install.
14. After installing the fan blade, verify that it does
not rub the top of the cavity. If required, remove
fan blade and tighten fan mounting nut (shown in
Step 6 above).
HEATING ELEMENTS
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove Right Side Cover and Fan Cover.
2. Disconnect lead wires from element being
replaced.
Fig. 48
3. Use a wrench on element inside oven while
removing and installing mounting nut.
Fig. 49
4. Remove nuts securing element being replaced.
NOTE: If mounting nuts will not slide over wire lead
backup nuts, loosen them or remove them.
Fig. 50
5. Remove screws securing element support
bracket to ceiling and remove bracket.
KA SERIES ELECTRIC ROTARY OVENS - REMOVAL AND REPLACEMENT OF PARTS
Page 17 of 72 F25294 Rev. A (0412)