Filter
Top Products
DOOR SWITCH MAGNET (KA7E
ONLY)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Open oven door and pull inner oven door to
overcome magnet hold to main door.
Fig. 28
2. Remove screws securing magnet housing and
remove magnet.
Fig. 29
3. Reverse procedure to install and check Door
Switch Adjustment (KA7E only; if required).
OUTER DOOR GLASS
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove door as outlined under DOOR.
2. Lay door on a flat padded surface.
3. Remove screws securing glass and remove
glass.
4. Install new glass in same orientation as old glass.
NOTE: Avoid contact such as bumping or hitting, or
abrasion of glass edges.
5. Install in reverse order and adjust door as
outlined under Door Adjustment.
WASH ARM, STRAINER PANS,
STRAIN PAN SUPPORT, DRAIN
SHROUD (KA7E ONLY)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Open oven door.
2. Use strainer pan handle and lift pan out of oven.
NOTE: Pan positions are not interchangeable.
Fig. 30
3. To remove wash arm, unscrew knurled part of
wash arm.
KA SERIES ELECTRIC ROTARY OVENS - REMOVAL AND REPLACEMENT OF PARTS
Page 13 of 72 F25294 Rev. A (0412)