Filter
Top Products
Fig. 138
6. Remove mini jack from front panel.
A. Use a small screwdriver or similar object to
carefully pry tabs out and work retainer clip
off jack.
Fig. 139
NOTE: Jack shown removed from oven for view. Also
notice that wires are polarity sensitive and must be
connected properly for correct operation.
Fig. 140
7. Identify and disconnect wires from mini jack
terminals.
8. KA7E only:
A. On opposite side of oven, identify and
remove wires from momentary switches.
B. Remove six nuts securing momentary
switch plate and work the plate from the
oven.
C. Remove two nuts securing the auto clean
overlay plate and its retaining plate.
D. Install momentary switch plate and auto
clean overlay plate on the opposite side of
oven.
KA SERIES ELECTRIC ROTARY OVENS - APPENDIX
F25294 Rev. A (0412) Page 70 of 72