Filter
Top Products
Fig. 70
4. Reverse procedure to install.
WATER LEVEL CONTROL BOARD
(KA7E ONLY)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
Certain components in this system are
subject to damage by electrostatic discharge during
field repairs. A field service grounding kit is available
to prevent damage. The field service kit must be used
anytime the control board is handled.
1. Remove Right Side Cover.
2. Remove four screws securing divider wall that
water level control board is fastened to.
Fig. 71
3. Pivot divider wall to access water level control
board.
4. Identify and disconnect wires.
Fig. 72
5. Use needle nose pliers to squeeze tabs on five
board supports. Work board off supports.
Fig. 73
6. Reverse procedure to install.
KA SERIES ELECTRIC ROTARY OVENS - REMOVAL AND REPLACEMENT OF PARTS
Page 23 of 72 F25294 Rev. A (0412)