Filter
Top Products
2-3
PERSONAL INJURY HAZARD
• Use both hands to remove oven doors.
• Do not use the handle or any portion of the
front frame or trim for lifting.
• Because of the weight and size of the
oven, two or more people are required to
move and safely install it.
Failure to properly grasp the oven doors or to
lift the oven properly could result in personal
injury or damage to the product.
WARNING
CAUTION: Do not remove the shipping base
or the shipping feet at the front lower cor-
ners of the oven. The shipping feet will
protect the lower oven trim until the oven is
inserted into the cabinet cutout.
REMOVING & REINSTALLING THE OVEN DOOR
To remove the oven door:
1. Install a pin in the hole of each oven door
hinge hanger.
2. Close the oven door as far as the two pins
will allow.
3. Grasp the sides of the door and lift the door
until it stops, then pull the hinge hangers
out of the slots.
To reinstall the oven door:
1. Grasp the sides of the door and tilt it back
at a slight angle, then insert the hinge
hangers into the hinge slots as far as they
will go.
2. Rotate the top of the door towards the
oven so the hinge hangers fit onto the
support pins.
3. Close the oven door as far as the pins will
allow, and make sure that the hinge hang-
ers are fully seated on the support pins. If
they are not seated properly, the door will
not close tightly and may be off-center. To
seat the hinge hangers, open the door
slightly, and push in on the bottom until the
hangers are fully seated.
4. Open the oven door to its fully open posi-
tion and remove the two hinge hanger
pins.
5. Close the oven door completely and check
it for proper operation and alignment.
Shipping Foot
Slot
Hinge Hanger
Door Pin Into Hinge Hanger Hole
Door Pin