Filter
Top Products
4-6
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so could result in death or
electrical shock.
WARNING
REMOVING THE OVEN LIGHT TRANSFORMER
& THE CONTROL POWER TRANSFORMER
CAUTION: When you work on the built-in
oven, be careful when handling the sheet metal
parts. Sharp edges may be present, and you
can cut yourself if you are not careful.
3. Remove the mounting screw from the
transformer you are servicing and unhook
the tab from the oven chassis slot.
1. Disconnect the electrical power to the
oven.
2. Remove the control panel from the oven
(see page 4-2, steps 1 through 6 for the
procedure). Position the control panel for-
ward so you can access either transformer.
Oven Light & Control Power Transformers
4. Disconnect the four wires from the LOAD
and LINE terminals of the transformer.
NOTE: The LOAD and LINE terminals are
different sizes so that you cannot make a
mistake when reconnecting the wires (see
below).
Transformer
Screws
Light
Transformer
Control Pwr
Transformer
Light Transformer
Control Power Transformer
Wht & Blk (Small)
Wht & Blk (Large)
(2) Blue
(Large)
(2) Red (Small)